Removing The Variable Baseline (If Option 001 Is Installed); Refitting The Variable Baseline; Location Of The Variable Baseline (Option 001) - HP 8114A Service Manual

Removing the Variable Baseline (If Option 001 is installed)

Refitting the Variable Baseline

N o t e
The Variable Baseline is, if original, or retrofitted, also mounted on the
power supply slide. See Figure 4-6.
Figure 4-6. Location of the Variable Baseline (Option 001)
1. Follow the instructions for Removing the Power Supply.
2. Remove the 4 screws at the bottom of the power supply slide,
securing the variable baseline module to the slide.
3. Remove the variable baseline module.
1. Refitting the variable baseline is the reverse procedure of removal.
The variable baseline module has two holes at the bottom - below the
connector - , These holes have to fit onto the two spacers which are
3
mounted on the power supply slide.
the
2. Secure variable baseline module with the 4 screws.
S U P P L Y
, SLIDE
MODULE
(OPTION 001;