Removing the Memory-Card Connector Board
Refitting the Memory-Card Connector Board
Note
TIMING
BOARD
NO081
Figure 4-15. Location of the Memory-Card Connector Board
1. Follow the instructions for Removing the Instrument Cover.
2. Disconnect the 2 ribbon cables connecting the memory-card
connector board to the motherboard.
3. Follow the instructions for Removing the output board fan.
4. Remove the screw securing the memory-card connector board to
the chassis. The screw is located at the outside of the chassis. See
Figure 4-15.
5. Remove the two screws securing the memory-card connector board
to the metal holder.
Refitting the memory-card connector board is the reverse procedure
of removal. Pleae note the following:
Insert the two guiding spacers of the memory-card connector board
into the two holes in the chassis.
Secure the memory-card connector board with the screw, p/n
0515-0886, from the outside of the chassis.
BOARD
MOTHERBOARD
SCREW