Removing The Timing Board; Refitting The Timing Board - HP 8114A Service Manual

Removing the Timing Board

Refitting the Timing Board

TIMING
BOARD
NO.08
TIMING BOARD
Figure 4-10. Location of the Timing Board
1. Follow the instructions for Removing the Cover.
2. Remove the 6 screws securing the timing board to the chassis. See
Figure 4- 10.
3. Disconnect the three cables which are close to the front panel.
4. Disconnect the two cables which are close to the rear panel, 5701
board,
on the timing
5. Slide the timing board back for about 10 mm to release the board
from its connection to the motherboard.
6. Remove the timing board.
Refitting the timing board is the reverse procedure of removal.
and J402/W701 on the output board.
Disassembly and Reassembly 4.13