Choke Cable Assembly Replacement - Toro Z MASTER 4000 Series Service Manual

Throttle Cable Assembly Unit Installation (continued)

Choke Cable Assembly Replacement

Choke Cable Assembly Unit Removal
Chassis: Service and Repairs
g346220
5. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the 4 (1/4-20 inch) torx screws securing the RH side pod to the RH
console. Remove the RH side pod from the RH console.
g346220
4. Remove the nut from the bottom side of the choke cable securing the cable
to the pod.
5. Disconnect the choke cable.
Figure 31
Figure 32
Page 5–16 4000 Series Z MASTER® Service Manual
3442-427 Rev A