Toro Z MASTER 4000 Series Service Manual page 61

MYRIDE® Removal (continued)
4000 Series Z MASTER® Service Manual
3442-427 Rev A
6. Loosen (do not remove) the 2 (3/8 inch) lock nuts securing the lower mount
of the rear shock to the ROPS.
g348060
7. Loosen (do not remove) the 1/2 inch lock nut securing the front shock upper
mount to the MYRIDE platform.
8. Remove the floor pan.
9. Open the 2 plastic clamps securing the fuel and vent lines.
g348062
10. Remove the 4 (5/16 inch) lock nuts securing the 2 (1 shown below) bearing
brackets to the chassis.
Note: Only 1 of the 4 lock nuts are shown in the image below.
Figure 40
Figure 41
Page 5–21 Chassis: Service and Repairs