Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
12.48
Changing the hydraulic clutch fluid
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
12.49
Removing the engine guard
12.50
Installing the engine guard
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
H00228-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 (
–
On the clutch slave cylinder, remove bleeder screw
syringe
H00254-10
–
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below top edge of con-
tainer
H00229-10
–
Position the cover with the membrane. Mount and tighten the screws.
–
Turn quick release
guard.
M00440-10
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Turn quick release
M01374-10
.
with membrane
with the appropriate hydraulic fluid.
p. 113)
.
counterclockwise until it disengages. Remove the engine
clockwise all the way.
.
and mount bleeding
4 mm (0.16 in)
67
of the master
- Quick Links:
- Service
Hide quick links:
Advertisement
Table of Contents
