Changing The Engine Oil And Oil Filter, Cleaning The Oil Screen - Husqvarna 2016 FE 250 Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.3

Changing the engine oil and oil filter, cleaning the oil screen

Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
»
If the engine oil is not at a level between lower edge
the level viewer:
–
Preparatory work
–
Park the motorcycle on a level surface.
–
Remove the engine guard. (
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug
Info
Do not remove screws
B01769-10
–
Remove screw plug
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
B01770-10
–
Position oil screen
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
B01771-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten oil drain plug
Guideline
Oil drain plug with magnet
B01772-10
Add engine oil. ( p. 98)
p. 67)

with the magnet and seal ring.

on both sides.

with oil screen

with the O-rings on a pin wrench.

with the O-ring.

with the magnet and a new seal ring.

and middle

and the O-rings.
M20x1.5 15 Nm (11.1 lbf ft)
M12x1.5 20 Nm (14.8 lbf ft)
97

of