12
SERVICE WORK ON THE CHASSIS
12.7
Removing the fork protector
12.8
Installing the fork protector
12.9
Removing the lower triple clamp
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
H00179-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
H00178-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Remove screws
–
Remove screws
–
Remove screws
S00899-10
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
–
Position the fork protector on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
S00899-11
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs. (
–
Remove the front fender. (
.
M8
.
M8
M8
(
p. 77)
p. 88)
and take off the clamp.
on the left fork leg. Take off the fork protector.
on the right fork leg. Take off the fork protector.
M6
M6
p. 42)
(
p. 77)
p. 43)
p. 48)
17 Nm (12.5 lbf ft)
15 Nm (11.1 lbf ft)
.
25 Nm
Loctite
®
243™
(18.4 lbf ft)
p. 86)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
p. 85)
44
.
.
.
.