Adding Engine Oil - Husqvarna 2016 FE 250 Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.4

Adding engine oil

Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
–
Remove screws
B01773-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
B01774-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter with engine oil and place it in the oil filter housing.
–
Lubricate the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
B01773-11
–
Remove filler plug
Engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
–
Install and tighten the oil filler plug with O-ring.
M00445-10 Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and/or death.
–
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (
–
Install the engine guard. (

. Remove the oil filter cover with the O-ring.

out of the oil filter housing.

and O-ring from the clutch cover and fill up with engine oil.
1.0 l (1.1 qt.)
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without
an effective exhaust extraction system.
p. 96)
p. 67)
M6 10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
98

.
p. 113)