Husqvarna 2016 FE 250 Owner's Manual page 66

12 SERVICE WORK ON THE CHASSIS
–
Check the chain sliding guard for wear.
» If the bottom edge of the chain bolt is in line with or below the chain sliding
guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten the chain sliding guard.
Guideline
Screw, chain sliding
guard
H00249-10
–
Check the chain sliding piece for wear.
» If the bottom edge of the chain bolt is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Screw, chain sliding piece
H00250-10
–
Check the chain guide for wear.
Info
Wear is visible on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain guide.
400985-01
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the chain guide.
Guideline
Remaining screws, chassis
Remaining nuts, chassis
H00251-01
Finishing work
–
Remove the motorcycle from the lift stand. (
M6 6 Nm
(4.4 lbf ft)
M8
M6
M6
p. 42)
64
Loctite ® 243™
15 Nm
(11.1 lbf ft)
10 Nm
(7.4 lbf ft)
10 Nm
(7.4 lbf ft)