Husqvarna 2016 FE 250 Owner's Manual page 60

12 SERVICE WORK ON THE CHASSIS
–
Mount and tighten screw
Guideline
Remaining screws, chassis
H00243-11
(FE EU)
–
Connect plug-in connector
tension, and secure with a new cable tie.
–
Install the fuel tank.
H00225-11
–
Lift the rear frame slightly and position the shock absorber.
–
Mount and tighten screw
Guideline
Screw, top shock
absorber
–
Position the rear frame.
H00245-10
–
Mount and tighten screws
Guideline
Screw, subframe
–
Remove screws
–
Mount and tighten screws
Guideline
Screw, subframe
M00389-11
–
Lower the swingarm.
H00224-11
–
Position the angle lever and linkage lever.
–
Mount and tighten screw cap
Guideline
Nut, linkage lever on angle lever
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
H00185-11

.
M8

of the lambda sensor, route the cable without
( p. 60)

.
M10

on both sides.
M8

on both sides.
 on both sides.
M8

.
M14x1.5

.
M10
25 Nm (18.4 lbf ft)
Loctite 2701™
60 Nm ®
(44.3 lbf ft)
Loctite ® 2701™
35 Nm
(25.8 lbf ft)
35 Nm Loctite ® 2701™
(25.8 lbf ft)
80 Nm (59 lbf ft)
60 Nm Loctite ® 2701™
(44.3 lbf ft)
58