Horn Button (Fe Eu/Au); Light Switch (Fe Eu/Au); Light Switch (Fe Us); Turn Signal Switch (Fe Eu/Au) - Husqvarna 2016 FE 250 Owner's Manual

Table of Contents

Advertisement

6
CONTROLS
6.6

Horn button (FE EU/AU)

6.7

Light switch (FE EU/AU)

6.8

Light switch (FE US)

6.9

Turn signal switch (FE EU/AU)

6.10

Emergency OFF switch (FE AU)

The horn button
Possible states
Horn button
Horn button
H00168-11
Light switch
Possible states
H00168-12
Light switch
Possible states
Light off – Light switch is pressed in up to the stop. In this position, the light is
switched off.
Light on – Light switch is pulled out to the stop. In this position, the low beam
and tail light are switched on.
M00355-10
Turn signal switch
Possible states
H00169-10
The emergency OFF switch
Possible states
S00891-10
is fitted on the left side of the handlebar.
in neutral position
pressed – the horn is actuated in this position.
is fitted on the left side of the handlebar.
Low beam – Light switch is in the central position. In this position, the
low beam and tail light are switched on.
High beam – Light switch is turned to the left. In this position, the high
beam and the tail light are switched on.
is located to the left of the speedometer.
is fitted on the left side of the handlebar.
Turn signal light off – Turn signal switch is in the central position.
Turn signal light, left, on – Turn signal switch is turned to the left.
Turn signal light, right, on – Turn signal switch is turned to the right.
is fitted on the right side of the handlebar.
Ignition off – the ignition circuit is open in this position, the engine
goes out if it was running, or does not start if it was off.
Ignition on – the ignition circuit is closed in this position and the
engine can be started.
15

Advertisement

Table of Contents
loading

Table of Contents