Setting Reserve Job - Oce CS665 Pro User Manual

9
9.7

Setting reserve job

The Reserve function allows you to set up a new job while a current job is in process. When the current job
is finished, the reserve job starts printing immediately.
Service can set the machine to disable this function. Contact your service representative, if desired.
0 Job settings: Max. 100
0 The reserve job setting will be available after the copier starts to scan the current job, and also available
anytime while printing the current job.
1
Display the Copy Screen with the message "Ready to set reserve job" displayed in the message area.
– When scanning job is started:
The following popup menu will be displayed.
Touch [Yes] to set reserve job. The Copy Screen for setting reserve job will be displayed.
– Touching [No] will return to the Machine Status Screen. In this case, touching [COPY] tab will display
the Copy Screen and allows you to make the reserve job setting.
If the machine is initially set to display the Copy Screen after scanning job is started, the above
popup menu will provide only the [Close] key. Touching [Close] will also display the Copy Screen to
make the reserve job setting.
– While printing job is in progress:
The message "Printing in progress" is displayed in the message area of the Machine Status Screen.
Touch [COPY] tab to display the Copy Screen with the message "Ready to set reserve Job".
2
Select copy conditions for the reserve job as desired, position original(s), then press [Start].
– Repeat steps 1 and 2. Up to 100 reserve jobs can be entered.
– To check and operate the reserve jobs, touch [JOB LIST] tab to display the Job List Screen. See
page 14-3 for details.
!
Detail
If any trouble occurs on a reserve job, see page 5-9.
9-44
Basic job settings
CS665 Pro