Setting Job During Warmup - Oce CS665 Pro User Manual

8
8.5

Setting job during warmup

While the machine is warming up after power is turned on, you can select copy conditions and start scanning
so that the machine may start printing immediately the machine engine is ready.
Service can set the machine to disable this function. Contact your service representative, if desired.
To scan the original during warmup
1
Turn on the main power switch and sub power switch of the machine.
– For details on turning on the power, see page 2-26.
2
Display the Copy Screen to check that the message "Ready to set reserve job" is displayed in the
message area.
– A few seconds after the Wake-up Screen appears on the touch panel, the Machine Status Screen
will be displayed.
Touch [COPY] tab to change the Machine Status Screen to display the Copy Screen, then check
that the message "Ready to set reserve job" is displayed in the message area.
3
Set the desired copy conditions, and enter the print quantity.
– For details on setting print quantity, see page 8-15.
4
Position the original FACE UP in the ADF or FACE DOWN on the original glass.
– For details on positioning the original, see page 8-12.
5
Press [Start].
– When scanning the original for the job is started, the popup menu will appear on the Copy Screen.
8-16
Before making copies
CS665 Pro