If "Memory Full" Message Is Displayed: Memory Overflow - Oce CS665 Pro User Manual

5
5.5

If "Memory Full" message is displayed: Memory overflow

In certain modes, this machine uses memory to make operations convenient and smooth flowing.
Occasional memory overflow may occur if the installed memory is inadequate for the job conditions selected,
and the machine will stop its operation with a popup menu displayed.
Take an appropriate measure described below to continue the operation.
Note
Should memory overflow occur frequently, it is recommended that you contact your service
representative to extend the memory capacity in your machine.
Memory overflow in current job
When memory overflow occurs while scanning the first job, the machine immediately stops and displays one
of the following popup menus.
1
When memory overflow occurs while scanning the first job, the machine immediately stops and
displays one of the following popup menus.
– To delete all the scanned data and discontinue the job, touch [Stop Job].
– To give up further scanning but print out all the data already scanned into memory, touch [Stop
Scan]. In this case, check the output sheets when printing is completed, and then reload the original
to continue the job.
2
Press [Start] on the control panel.
– The machine starts scanning for the reloaded original to complete the job.
Note
If the job settings include Booklet Pagination, the [Stop Scan] key will not appear.
Reminder
The original to be reloaded should be less in page count than the first loaded in order to prevent another
memory overflow.
5-12
Troubleshooting
CS665 Pro