Opening And Closing The Shroud And Removing And Installing The Right Side Cover (Rst90) - Yamaha RST90G Owner's Manual

Periodic maintenance and adjustment
1. Windshield stay rubber cover
5. Loosen the quick fastener screws.
6. Lift up the rear of the top cover, discon-
nect the main switch coupler, and then
remove the cover.
1. Top cover
2. Main switch coupler
To install the top cover
1. Connect the main switch coupler.
2. Place the top cover in the original posi-
tion, making sure to fit the projections on
the cover into the slots in the headlight
unit.
62
1
3.
4.
5.
1
6.
7.
ECS00373
NOTICE
 Make sure that all cables, hoses and
2
 When installing the shroud and covers,
ESU14770
Opening and closing the shroud
and removing and installing the
right side cover (RST90)
EWS00811
Be sure the shroud and right side cover
are secured before operation. A loose
shroud or cover could move and cause
loss of control.
Tighten the quick fastener screws.
Place the windshield stay rubber covers
in their original position.
Pass the brake hose, throttle cable, park-
ing brake cable and wire harness
through the cable guide, place the cable
guide in the original position, and then in-
stall the screws.
Connect the auxiliary DC jack coupler.
Install the left side cover and the shroud.
leads are routed properly before install-
ing the shroud and covers.
be sure to tighten the fasteners secure-
ly.
WARNING