Drive Chain Housing - Yamaha RST90G Owner's Manual

Periodic maintenance and adjustment
RST90TF / RST90TFL / RST90TFY
1
1. Left lower cover
14. Install the drive guard, and then install
the left side cover and the shroud, or
close the shroud.
ESU13926

Drive chain housing

To check the drive chain housing oil
level
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Remove the shroud and the right side
cover [RST90TF /
RST90TFY (see page 60 for the proce-
dures)], or open the shroud [RST90 (see
page 62 for the procedures)].
3. Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
RST90TF / RST90TFL / RST90TFY
1. Dipstick
82
RST90TFL /
1
RST90
1. Dipstick
4. Remove the dipstick and check that the
oil is between the maximum and mini-
mum level marks on the "REVERSE" side
of the dipstick. If the oil is below the min-
imum level mark, add sufficient oil of the
recommended type to raise it to the
maximum level mark. NOTICE: Make
sure that no foreign material enters
the drive chain housing.
1. Maximum level mark
2. Minimum level mark
[ECS00532]