Periodic maintenance and adjustment
1. Handlebar cover
2.
Loosen the handlebar bolts.
1. Handlebar bolt
3.
Move the handlebar up or down to adjust
the handlebar height to the desired posi-
tion. NOTICE: Make sure that the pro-
jection on the handlebar is not
installed into the area shown.
88
1. Area where projection cannot be installed
4.
Tighten the front handlebar bolts to the
specified torque, and then tighten the
rear handlebar bolts to the specified
torque. NOTICE: Make sure each han-
dlebar holder is installed so that the
smaller gap is facing forward.
[ECS00572]
1. Forward
2. Small gap
Handlebar bolt tightening torque:
23 Nm (2.3 m·kgf, 17 ft·lbf)
5.
Install the handlebar cover.
[ECS00583]