Removing And Installing The Shroud And Covers - Yamaha RS VENTURE 2014 Owner's Manual

Periodic maintenance and adjustment
ESU14720
Removing and installing the
shroud and covers
EWS00092
WARNING
Be sure shroud and covers are secured
before operation. A loose shroud or cover
could move and cause loss of control.
Shroud
To remove the shroud
Loosen the fasteners, slowly raise the
shroud, and then unhook the shroud from the
shroud stay.
1
1. Fastener
2. Shroud
3. Shroud stay
To install the shroud
Hook the end of the shroud onto the shroud
stay, slowly lower it to the original position,
and then tighten the fasteners.
1. Shroud stay
50
Left and right side covers
To remove a side cover
1. Remove the shroud. (See the above pro-
cedure.)
2. Loosen the fasteners, pull outward on
the areas shown, and then slide the side
cover forward to remove it.
2
1. Fastener
2. Left side cover
To install a side cover
1. Fit the projection on the rear of the side
cover into the hole in the fuel tank cover.
3
2. Fit the projections on the side cover into
the slots as shown.
1
2