Yamaha RST90G Owner's Manual page 106

Periodic maintenance and adjustment
Specified fuses:
Main fuse:
40.0 A
EPS fuse:
30.0 A
Fuel injection system fuse:
10.0 A
Ignition fuse:
15.0 A
Headlight fuse:
20.0 A
Signaling system fuse:
7.5 A
Auxiliary DC jack fuse:
3.0 A
Helmet shield heater jack fuse:
3.0 A
Spare fuses:
20.0 A, 15.0 A, 10.0 A, 7.5 A, 3.0 A
11. Connect the negative battery lead by in-
stalling the bolt.
12. Install the battery cover, and then hook
the battery band onto the holder.
13. Install the air filter case by reversing the
removal steps 4–7.
14. Install the headlight unit, making sure to
fit the slots on its bottom onto the projec-
tions on its stay.
1
2
1. Slot
2. Projection
15. Fit the weatherstrip on the headlight unit
into the recess in the top of the air filter
case cover.
100
1. Weatherstrip
16. Install the headlight unit bolts and wind-
shield stay bolts, and then tighten them
to their specified torques.
Tightening torques:
Headlight unit bolt:
3.0 Nm (0.30 m·kgf, 2.2 ft·lbf)
Windshield stay bolt:
14 Nm (1.4 m·kgf, 10 ft·lbf)
17. Install the top cover, the left and right
side covers, and the shroud.
TIP
If the fuse immediately blows again, ask a
Yamaha dealer to inspect the snowmobile.
RST90
The main fuse is located under the air filter
case. The fuse box, which contains the fuses
for the individual circuits, is located behind
the right side cover.
1. Open the shroud.
2. Remove the right side cover. (See page
60 for removal procedures.)
3. Unhook the air filter case fastener.
1