Tool Kit; Removing And Installing The Shroud And Covers - Yamaha Vector RS90RX Owner's Manual

Periodic maintenance
ESU11740

Tool kit

The owner's tool kit has the tools which are
sufficient for most periodic maintenance and
minor repairs. A torque wrench is also neces-
sary to properly tighten nuts and bolts.
1. Tool kit
ECS00360
CAUTION:
Before starting the engine, make sure that
the tool kit is properly seated in its holder
and is securely fastened.
NOTE:
If you do not have a torque wrench available
during a service operation requiring one, take
your snowmobile to a Yamaha dealer to
check the torque settings and adjust them if
necessary.
ESU12891
Removing and installing the
shroud and covers
Shroud
To remove the shroud
Loosen the fasteners, slowly raise the shroud,
and then unhook the shroud from the shroud
stay.
40
1. Fastener
2. Shroud
To install the shroud
Hook the end of the shroud onto the shroud
stay, slowly lower it to the original position,
and then tighten the fasteners.
1. Shroud stay
Left and right side covers
To remove a side cover
1. Remove the shroud. (See the above pro-
cedure.)
2. Loosen the fasteners, and then remove
the side cover.