Server Menu - Fujitsu PRIMERGY RX300 S2 User Manual

Chapter 8 Hardware Configuration/Utilities

8.2.12 Server Menu

Configures server settings.
Main
O/S Boot Timeout:
Action:
Timeout Value:
ASR&R Boot Delay:
Power Cycle Delay:
Boot Retry Counter:
Diagnostic System:
Temperature Monitoring:
Memory Scrubbing:
CPU Status
Memory Status
Console Redirection
RomPilot
Info
F1
Esc Exit
Item
O/S Boot Timeout
242
PhoenixBIOS Setup Utility
Advanced Security Server
[Disabled]
[Reset]
[0]
[2]
[5]
[3]
[Disabled]
[Disabled]
[Enabled]
-/+ Change Values
Select Item
Select Menu Enter Select
table: Items on the Server Menu
Setting
• Disabled (at the time of
purchase)
• Enabled
Exit
Item Specific Help
F9 Setup Defaults
Sub-Menu F7 Previous Values
Description
Sets whether to enable or disable the OS Boot
Monitoring function, when ServerView is installed
to the OS.
If for some reason booting the operating system is
interrupted when this function is enabled, the
system will automatically restart.
Note:
The OS Boot Monitoring function can also
be enabled or disabled from ServerView.
If ServerView is not installed to the OS, be
sure to set to [Disabled].
If the setting is enabled, the server may
automatically turn off or restart
unexpectedly.
Even when ServerView is installed to the
OS, if starting the system while the
ServerStart CD-ROM or DOS floppy disk is
inside, be sure to disable the OS Boot
Monitoring function.
If the system is started with this function
enabled, the server may automatically turn
off or restart improperly.
If the OS Boot Monitoring function is
needed, it should be reset to enabled before
resuming normal server operation.
When setting this function, refer to
"ServerView User's Guide" to fully learn
about its specifications, in order to use it
properly with the correct settings.