Connecting To An External Device; Interface Connector; How To Connect An Interface Connector - Contec F&eIT Series User Manual

Connecting to an External Device

Interface Connector

How to Connect an Interface Connector

When connecting the Module to an external device, you can use the supplied
connector plug. When wiring the Module, strip off approximately 7 - 8 mm of the
covering for the cable, and insert the bare wire by pressing the orange button on the
connector plug. Releasing the orange button after the wire is inserted to fix the cable.
Compatible wires are AWG 28 - 20.
C H
C H
A B Z D1
Device
ID
CH
CH
CNT24-2
Figure 3.1.
Note!
Removing the connector plug by grasping the cable can break the wire.
CNT24-2(FIT)GY
Press this section to insert
the wire material.
6
- Connector used:
2.5mm pitch, 9-pin type, 4.0A nominal current
PCOM
PA
PB
MC0,5/9-G-2,5 connector (made by Phoenix Contact Corp.)
PZ
PD1
EQ.P
EQ
EQ.N - Applicable plug:
Front-operable spring gauge type
PCOM
PA
FK-MC0,5/9-ST-2,5 plug (made by Phoenix Contact Crop.)
PB
PZ
Applicable wire: AWG 28 - 20
PD1
EQ.P
EQ
EQ.N
Connecting an Interface Connector and Connectors That Can
Be Used
Connecting to an External Device
7 - 8mm
9