Connecting To An External Device - Contec CONPROSYS CPS-MCS341-DS1-111 Reference Manual

CPS-MCS341-DS1-111, CPS-MCS341-DS1-131 Reference Manual (Hardware)

2. Connecting to an External Device

Use the supplied connector plug to connect the product to an external device.
The following example describes how to make the connecting cable with a supplied connector.
Example of making the connecting cable with a 3-pin connector
Applicable wires : AWG20 - 16
1
Strip off approximately 7mm (plus or minus 0.5mm) of the covered part of a cable and insert it
to the opening.
2
After the insertion, secure the stripped part by turning screws with a slotted driver to prevent it
from disconnecting.
Removing the connector plug by grasping the cable can break the wire. Always grasp the

connector to remove it.
Tightening torque of the supplied connector is 0.19 N·m.

Strip off approximately 7mm (plus or minus 0.5mm) of the covered part of a cable to connect

with the connector.
— —
Installation
Connection cable
The supplied
connector
CAUTION
— 48 —
Power Supply
or
External Device