Contec F&eIT Series User Manual page 57

Using the Memory Address Map
- Start registers by channels / Start register mask configuration by channels
+18h
+19h
Start registers by channels (+18h)
CH1 to CH0
0 : Stop
1 : Start
If started from the module start register, each channel is enabled (1 is turned on). If
any one of the channels is ON, the module start register is also made active.
Start register mask configuration by channels (+19h)
The corresponding bit 1 reflects the channel for the start register value by channel.
0 : Not processed.
1 : Start register value by channel is reflected.
52
D7 D6 D5 D4
- - -
- - -
Turns ON/OFF for each channel.
D3 D2 D1
- - - CH1
- - - CH1
D0
CH0
CH0
CNT24-2(FIT)GY