2. Connecting to an External Device
1. Connecting an Interface Connector
Use the supplied interface connector (plug connector) to connect the product to an external device.
The following example describes how to make the connecting cable with the interface connector
(connector plug).
[Attached connector]: European type terminal 3.5 pitch 10-pin jack connector
[Supplied connector]: European type terminal 3.5 pitch 10-pin plug connector
[Compatible cable]: AWG28 - 16
1
Strip off approximately 7mm (plus or minus 0.5mm) of the covered part of a cable and insert it
to the opening.
2
After the insertion, secure the stripped part by turning screws with a slotted driver to prevent it
from disconnecting.
Removing the connector plug by grasping the cable can break the wire. Always grasp the
interface connector to remove it.
Do not set or remove the interface connector when the power is on or during the
communication.
—
Installation
AI-1608VIN-USB / AI-1608AIN-USB Reference Manual
CAUTION
— 45 —
—