Table of Contents
Advertisement
3. Connecting to an External Device
Interface Connector
How to Connect an Interface Connector
When connecting the Module to an external device, use the attached connector plug. When wiring the
Module, strip off approximately 7 - 8 mm of the covering for the cable, and insert the bare wire by
pressing the orange button on the connector plug. Releasing the orange button after the wire is inserted
fixes the cable. Applicable wire size is AWG 28 - 20.
RUN
ERR
Press this section to insert
the wire material.
6
Device
ID
PT
JPT
2
on
3W
4W
1
CH0
a0
A0
B0
b0
CH1
a1
A1
B1
b1
NC
CH2
a2
A2
B2
b2
CH3
a3
A3
B3
b3
NC
PTI-4
Figure 3.1. Connecting an Interface Connector and Connectors That Can Be Used
CAUTION
-
Leave the NC pin unconnected.
-
Removing the connector plug by grasping the cable can break the wire.
PTI-4(FIT)GY
- Applicable plug:
Front-operable spring gauge type
FK- MC0,5/9-ST-2,5 plug
(made by Phoenix Contact Corp.)
Applicable wire: AWG 28 - 20
3. Connecting to an External Device
7 - 8mm
11
Advertisement
Table of Contents
