Connecting To An External Device - Contec CPSN-SSI-4C Reference Manual

2. Connecting to an External Device

When connecting the product to an external device, use the supplied connector.
When wiring the connector, strip off 8 mm ± 0.5 mm of the wires covering, and then insert this
stripped part into the connectors opening.
While pushing the orange part in the center of the connector with a precision screwdriver or a similar
tool, insert the cable into the round connection hole. After that, release the pushed part to fix the
cable in place.
You can also insert cables without pushing on the orange part of the connector by using a ferrule
terminal.
Removing the connector plug by grasping the cable can break the wire.
About a caution mark
Please use copper wires that withstand the temperature of 75 degrees Celsius and higher.
—
Installation
CPSN-SSI-4C Reference Manual (Hardware)
CAUTION
on the product:
— 25 —
—