Epson PowerLite 826W+ User Manual page 147

If you're using a projector keyword, it changes each time you turn
■
the projector off and then on again. Check the projector's
keyword on the LAN standby screen and enter it at the prompt.
■ If you're using AirPort, check the configuration of your network.
Start the AirPort Admin utility, select your base station, click
click
Configure and
tab. If you set up your projector to connect in DHCP mode, turn
on
Distribute IP Addresses
If you're using AirPort and DHCP is turned off on your
■
projector's Access Point mode advanced settings screen, make sure
Distribute IP Addresses
If you're using Access Point mode and you're connecting to the
■
wrong network, you may be experiencing signal interference from
another network. Try resetting your access point or base station,
then restart EasyMP Network Projection.
If you're using AirPort, the projector's SSID should match the
■
AirPort network name, not the name of the AirPort base station.
To check the network name, start the AirPort Admin utility,
select your base station, and click
. The network name appears on the AirPort tab.
All Settings
■ If you're prompted for a password when you connect, enter the
WEP encryption key (if you're using WEP encryption).
You are not receiving mail when a projector problem occurs.
Make sure the Mail settings are correct in the Network menu. For
■
details, see page 94.
To receive mail notification when the projector is in standby
■
mode, you need to set
in the Extended menu. See page 117.
■ Make sure the network cable or Wireless 802.11a/b/g Module
(PowerLite 85+/825+/826W+ only) is securely and correctly
connected.
Make sure power is being supplied to the projector.
■
. Click the
Show All Settings
and
Share a Single IP Address
is off.
Configure
to
Standby Mode Communication On
Network
.
. Then click
Show
Solving Problems
147