Epson PowerLite 826W+ User Manual page 134

Status lights (continued)
Light Status
Flashing red
Flashing
orange
Red
Flashing
orange
Flashing red
Solving Problems
134
Description
There is a problem with the fan or temperature sensor. Stop using the
projector, disconnect the power cable, and contact Epson as described
on page 149.
Rapid cooling is in progress. Although this is not an abnormal condition,
projection will stop automatically if the temperature rises higher. Make
sure there is plenty of space around the projector for ventilation, and that
the air filter and vents are clear. If you're using the projector above 4900
feet (1500 m), turn on High Altitude Mode; see page 117.
The projector is overheating, which turns the lamp off automatically.
Wait until the cooling fan stops, then unplug the power cord. Plug the
power cord back in and press the
temperature is not above 95 °F (35 °C), and there is plenty of space
around the projector for ventilation. If you're using the projector above
4900 feet (1500 m), turn on High Altitude Mode; see page 117.
The air filter or vent may be clogged. Clean them or replace the air filter
as described on page 121.
If the projector continues to overheat after you clean or replace the air
filter, contact Epson for help as described on page 149.
Warning: Except as specifically explained in this User's Guide, do not
attempt to service this product yourself.
It's time to replace the lamp. See page 122 for instructions. If you
continue to use the lamp after the replacement warning, there is an
increased possibility that the lamp may break.
The lamp may be burnt out. First make sure the lamp cover is securely
installed. If that's not the problem, let the lamp cool, remove the lamp,
and check if it is cracked. If it is cracked, replace it as described on
page 122. If it not cracked, reinstall the lamp and try using it again.
The air filter or vent may be clogged. Clean them or replace the air filter
as described on page 121.
If these steps do not resolve the problem, contact Epson as described on
page 149.
P power button. Make sure the room