Epson PowerLite 826W+ User Manual page 142

Solving Problems
142
Make sure your computer's resolution setting is correct. Ideally, it
■
×
should be 1280 800 to match the projector's native resolution
for the PowerLite 826W+, or 1024
84+/85+/824+/825+. If this option isn't available, select one of
the other compatible video formats listed on page 157.
If you are projecting from a computer, press the Auto button on
■
the remote control. If that doesn't work, you can adjust the
Tracking and Sync settings in the Signal menu (see page 106).
The image is blurry.
■ There may be dirt or smears on the lens. Clean the lens as
described on page 120.
■ Adjust the focus using the focus ring (see page 27).
Make sure the lens is not fogged by condensation. You may need
■
to wait before using the projector after moving it from a cold
environment to a warm environment.
■ Make sure the projector is facing the screen squarely, to eliminate
the need for keystone correction.
■ Adjust the
Sharpness
When you change video settings, you should be able to see the
effect on the screen immediately. If you're projecting from a
computer, you may also need to adjust the tracking and sync as
described in the next section. If you don't like the new settings,
you can always select
settings.
Make sure the projector is within the recommended distance
■
range (see page 16).
×
768 for the PowerLite
setting on the Image menu (see page 105).
to return to the factory default
Reset