Electrical / Refrigeration; Merchandiser Electrical Data; Field Wiring; Power Switch - Hussmann GSVM Installation & Service Manual

P/N 0515275_F

MERCHANDISER ELECTRICAL DATA

Refer to Appendix A of this manual or the
merchandiser's serial plate for electrical
information.

FIELD WIRING

Field wiring must be sized for component
amperes stamped on the serial plate. Actual
ampere draw may be less than specified.
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES

ELECTRICAL CONNECTIONS

All wiring must be in compliance with NEC
and local codes. All electrical connections for
GSVM-4072 and 5072 self-contained are to be
made in the electrical Handy Box located
behind the removable base panel at the left end
of the merchandiser when facing the discharge
air honeycomb. GSVM-4060 is provided with a
power cord.

POWER SWITCH

The main electrical power switch is located
behind the front louvered access panel. The
power switch must be turned OFF before
servicing the merchandiser.
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electrical
shock, always disconnect the electrical power
at the main disconnect when servicing or
replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

ELECTRICAL / REFRIGERATION

ELECTRICAL OUTLET:

Before the merchandiser is connected to any
wall circuit, use a voltmeter to check that the
outlet is at 100% of the rated voltage. The wall
circuit must be dedicated for the merchandiser.
Failure to do so voids the warranty. Do not use
an extension cord. Never plug in more than
one merchandiser per electrical circuit.
• Always use a dedicated circuit with the
amperage stated on the unit.
• Plug into an outlet designed for the plug.
• Do not overload the circuit
• Do not use long or thin extension cords.
Never use adapters.
• If in doubt, call an electrician.
Risk of Electric Shock. If cord or plug
becomes damaged, replace only with
a cord and plug of the same type.
Merchandiser must be grounded.
Do not remove the power supply cord ground.
GSVM Open Vertical Merchandisers
2-1
GSVM-4060 has
a factory-installed
power cord that is
attached at the
electrical box.