Disassembly; Door Assembly Removal; Door Gasket Removal; Outer Door Panel Assembly Removal - Viking RVGR3305B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Door Assembly Removal

1. Open door completely. Place pins supplied with unit
in pin holes.
Important: For personal safety, only use pins supplied
with unit. Pins can be ordered if needed #005116-000.
2. Remove screws and hinge trim from range.
3. Gently close door until pins stop door.
4. Lift door up and out.
Door Assembly
Note: If the door needs to be adjusted up or down,
loosen hinge trim screws. Adjust the screws
located between the door and kick plate using a
/ " hex head Allen wrench. Tighten hinge trim
5
32
screws after adjustment is made.
5. Reverse procedure for installation.
©2013 Viking Preferred Service

Door Gasket Removal

1. Open door and insert a narrow tool or small, flat-
2. Remove the door gasket from two holes in the bottom
3. Reverse procedure for installation.

Outer Door Panel Assembly Removal

1. Remove oven door (see Door Assembly Removal).
2. Place the door, handle side down, on a protected
3. Remove screws that attach the outer door panel
Adjustment Screw
3. Lift the inner door panel assembly from the outer
4. Reverse procedure for installation.
blade screwdriver into the center of each clip and pry
upward.
of the door liner.
surface.
assembly to the inner door panel assembly.
door panel assembly.

Disassembly

21