Disassembly; Door Assembly Removal; Door Gasket Removal - Viking VGCC530 Service Manual

Hide thumbs Also See for VGCC530:

Table of Contents

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test

procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.

Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Condition Requirements:

Door Lowered

1. Place pins supplied with unit in pin holes.

Note: For personal safety, only use pins supplied with

unit.

2. Remove screws and hinge trim from range.

3. Close door until pins stop door.

4. Lift door up and out.

Door Assembly

Note: If the door needs to be adjusted, loosen hinge

trim screws. Adjust the screws located between

the door and kick plate using a

allen wrench. Tighten hinge trim screws after

adjustment is made.

5. Reverse procedure for installation.

Condition Requirements:

Door Lowered

1. Insert a narrow tool or small ﬂ at-blade screwdriver

into the center of each clip and pry upward.

2. Remove the door gasket from two holes in the bottom

of the door liner.

3. Reverse procedure for installation.

Adjustment Screw

" hex head

Disassembly

Table of Contents