Sport Mode Indicator Light; Selector Lever/Gear Position Indicator; Turn Signal Indicator Lights; High Beam Indicator Light - Subaru 2007 B9 Tribeca Owner's Manual

3-20
Instruments and controls
chapter 2.)
If the indicator light does not flash, it may
indicate that immobilizer system may be
faulty. Contact your nearest SUBARU
dealer immediately.
In the event that an unauthorized key (for
example, an unauthorized duplicate) is
used, the security indicator light comes
on.
SPORT mode indicator
light
This light comes on when the ignition
switch is turned to the "ON" position and
goes out after the engine has started.
When the selector lever is moved to the
manual gate, the SPORT mode is select-
ed and the indicator light comes on. (Refer
to the "Automatic transmission" section in
chapter 7.)
Automatic transmission control
system warning
If the light flashes after the engine starts,
it may indicate that the automatic trans-
mission control system is not working
properly. Contact your nearest SUBARU
dealer for service immediately.
Selector lever/Gear position
indicator
The selector lever/gear position indicator
shows the position of the selector lever.
When manual mode is selected, the gear
position indicator shows the current gear
position and the upshift/downshift indica-
tor illuminates. (Refer to the "Automatic
transmission" section in chapter 7.)
Turn signal indicator
lights
These lights show the operation of the
turn signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be
burned out. Replace the bulb as soon as
possible. Refer to the "Replacing bulbs"
section in chapter 11.
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also comes on when
the headlight flasher is operated.
Cruise control indica-
tor light
The cruise control indicator light comes on
300266
when the ignition switch is turned to the
"ON" position and goes out after approxi-
mately 3 seconds.
This light comes on when the "CRUISE"
main switch is pressed.
NOTE
If you move the cruise control lever or
press the main switch button while
turning the ignition switch "ON", the
cruise control function is deactivated
and the "CRUISE" indicator light flash-
es. To reactivate the cruise control
function, turn the ignition switch back
to the "ACC" or "LOCK" position, and
then turn it again to the "ON" position.