Head Restraint Adjustment - Subaru 2007 B9 Tribeca Owner's Manual

Retrieval of seat position
Never retrieve the seat position
while driving to avoid the possibil-
ity of loss of vehicle control and of
personal injury.
Perform the seat position retrieval
before driving. Be sure to confirm
that the selector lever position is
in the "P" position. Do not drive
until the retrieval of the seat posi-
tion is complete.
Be sure to press the correct but-
ton to retrieve your registered
seat position. If the seat position
is not optimum for you, it may ad-
versely affect your driving and
may reduce the effectiveness of
the seatbelt. That could result in
an accident involving serious in-
jury or death.
When retrieving a registered seat
position, make sure the hands,
feet and possessions of rear seat
passengers are clear of the seat
adjusting mechanism.
When any trouble or a malfunc-
tion occurs during the retrieval of
the seat position, stop the retriev-
al of the seat position using any of
the control switches for manual
adjustment, seat memory set but-
ton, seat memory registered but-
ton 1 or 2.
2
1
SET
1. With the transmission selector lever in
the "P" position, press the desired button
"1" or "2".
2. The chime sounds once and the seat
moves to the registered position.
3. When the seat moves to the registered
position, the chime sounds twice.
Seat, seatbelt and SRS airbags
NOTE
If a new position is registered for the
same button, the previous seat posi-
tion is deleted.
Even if the battery is disconnected,
the registered seat position is not de-
leted.

Head restraint adjustment

100805
To raise the head restraint, pull it up. To
lower it, push the head restraint down
while pressing the release button on the
top of the seatback.
The head restraint should be adjusted so
that the center of the head restraint is clos-
est to the top of the occupant's ears.
1-5
100355
– CONTINUED –