Sport Mode Indicator Light; Select Lever/Gear Position Indicator; Turn Signal Indicator Lights; High Beam Indicator Light - Subaru 2011 Tribeca Owner's Manual

3-20
Instruments and controls
If the indicator light does not flash, it may
indicate that immobilizer system may be
malfunctioning. Contact your nearest
SUBARU dealer immediately.
In the event that an unauthorized key (for
example, an unauthorized duplicate) is
used, the security indicator light illumi-
nates.
&
SPORT mode indicator
light
This light illuminates when the ignition
switch is turned to the "ON" position and
turns off after the engine has started.
When the select lever is moved to the
manual gate, the SPORT mode is se-
lected and the indicator light illuminates.
Refer to "SPORT mode" F7-18.
& Select lever/Gear position in-
dicator
The select lever/gear position indicator
shows the position of the select lever.
When manual mode is selected, the gear
position indicator shows the current gear
position and the upshift/downshift indica-
tor illuminates. Refer to "Automatic trans-
mission" F7-12.
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to "Replacing bulbs" F11-37.
&
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
&
Cruise control indica-
tor light
The cruise control indicator light illumi-
nates when the ignition switch is turned to
the "ON" position and turns off after
approximately 3 seconds.
This light illuminates when the "CRUISE"
main switch is pressed.
NOTE
. If you move the cruise control lever
or press the main switch button while
turning the ignition switch "ON", the
cruise control function is deactivated
and the cruise control indicator light
flashes. To reactivate the cruise control
function, turn the ignition switch back
to the "Acc" or "LOCK" position, and
then turn it again to the "ON" position.
. If this indicator light and the CHECK
ENGINE warning light/malfunction in-
dicator lamp flash simultaneously dur-
ing driving, have the vehicle checked
by your nearest SUBARU dealer.