Subaru 2007 B9 Tribeca Owner's Manual page 168

– Defroster button
To defrost or dehumidify the windshield
and front door windows, push the defrost-
er button " ". When the "
is pushed, regardless whether the air con-
ditioner is operating or not, outside air is
drawn into the passenger compartment,
the air conditioner compressor turns on,
air flow is directed towards the windshield
and front door windows, and the indicator
light on the button comes on.
After eliminating the fogging from the
windshield, return the climate control sys-
tem to the AUTO mode by pushing the
"AUTO" button or turn off by pushing the
"OFF" button.
Alternatively, push the "
again to return the system to the setting
that was selected before you activated the
defroster.
Fan speed control dial
400511
The fan speed control dial has 7 positions:
" button
AUTO position and 6 different fan speed
positions.
The fan speed is shown on the center of
the dial.
With the fan speed control dial in the
AUTO position, the fan speed changes
automatically corresponding the various
conditions: air temperature inside and out-
side of the passenger's compartment, in-
tensity of the sunlight, etc.
" button
A/C – Air conditioner button
If the windshield starts to fog when the cli-
400512
mate control system is operated in the
AUTO mode, push the air conditioner but-
ton to defog and dehumidify.
When this button is pushed, the air condi-
tioner compressor turns on and the indica-
tor light on the button comes on. After
eliminating the fogging from the wind-
shield, set the system back to the AUTO
mode by pushing the "AUTO" button.
NOTE
The air conditioner compressor does
not operate when the outside air tem-
perature is below 32°F (0°C).
4-7
Climate control
400513
– CONTINUED –