Rear Window Wiper And Washer Switch - Subaru 2007 B9 Tribeca Owner's Manual

3-32
Instruments and controls
NOTE
The windshield washer fluid warning
light comes on when the washer fluid
level in the tank has dropped to the
lower limit. If the warning light illumi-
nates, refill the tank with fluid. For the
tank refilling method, refer to the
"Windshield washer fluid" section in
chapter 11.
Rear window wiper and wash-
er switch
300544
: Washer (accompanied by wiper opera-
tion)
ON: Continuous
INT: Intermittent
OFF: Park
: Washer
Rear wiper
To turn the rear wiper on, turn the knob on
the end of the wiper control lever upward
to the "INT" or "ON" position.
To turn the wiper off, return the knob on
the end of the lever to the "OFF" position.
With the switch turned to the "INT" posi-
tion, the rear wiper will operate intermit-
tently at intervals corresponding to the ve-
hicle speed (longer when the vehicle
speed is low; shorter when the vehicle
speed is high).
When you subsequently move the selec-
tor lever of the automatic transmission to
the "R" position, the rear wiper will switch
to continuous operation. When you move
the selector lever from the "R" position to
some other position, the rear wiper will re-
turn to intermittent operation.
Washer
To wash the rear window while the rear
wiper is operating, turn the knob on the
end of the wiper control lever upward to
the " " position. The washer fluid
300782
sprays until you release the knob.
To wash the rear window when the rear
wiper is not in use, turn the knob on the
end of the wiper control lever downward to
the " " position. The washer fluid
sprays and the wiper operates until you
release the knob.