Table of Contents
Advertisement
Setup
Setup Screens
Rev .53 and later:
Beginning firmware revision .53 and later, the setup menu was sub-divided to provide
easier access to specific items. The setup and control remain the same as described later
in this section.
The divisions and their sub-menus are as such:
Monitor and control –
•
Configure the Ethernet interface
•
Configure the RS232 (COM1) interface
•
Configure the RS485 (COM2) interface
Initial setup –
•
Change the external RF inhibit polarity (NO/NC)
•
Redundancy Mode
•
Set System identifiers for Ethernet connected systems
•
Select High Voltage state at start-up
•
Cathode Current Optimization
•
Set buzzer volume
•
Set touch-screen volume
•
Set Display Backlight level
•
Set time and date
RF Options –
•
View sample port coupling factors
•
Select system offset power readings
•
Select RF power alarm and fault limits
MNC-0400-071
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
Page 34 of 53
Operation
Revision 4
Advertisement
Chapters
Table of Contents
