Table of Contents
Advertisement
Maintenance intervals
Component/
Cleaning/care
wearing part
If a corresponding
Condensate
message is
tank
displayed.
Depending on local
conditions after
Air filter
approx. 100 oper-
ating hours
Tubes
- Smart
After approx. 200
technology
operating hours
- CPI
Tubes
After approx. 200
- Electronic
operating hours
Power
Facial tanners
When required
After approx. 200
LED booster
operating hours
Acrylic pane
When required
(bench)
Acrylic panes
When required
(others)
Shoulder
When required
tanner
Clean
Air-
exchangers
conditioning
500 - 600 operating
unit
hours and check the
condensate pump.
Check after 500
Air hoses
- 600 operating
hours.
After approx. 2000
Springs of the
operating hours /
canopy drive
1 year
Check and grease
Ropes of the
after 500 - 600
canopy drive
hours.
Protective
Test the switches
pane-switch
with each removing
- Filter panes
of filter panes
aquaCool Filter
aquaCool
When required
nozzles
Replacement
When required
-
Typical value after
about 1100 oper-
ating hours. For
further information
see data sheet.
Typical value after
about 800 oper-
ating hours. For
further information
see data sheet.
After approx. 500
- 600 operating
hours
When required
After approx. 1500
operating hours
When required
After approx. 600
operating hours
the
heat
after
When required
When required
After approx.
10000 operating
hours / 4 years
Replace all
ropes after 3000
operating hours.
When required
After approx.
2000 operating
-
hour
and/or 1 year
After approx. 1000
operating hours
Tools and aids
Hexagon socket screwdriver (SW 4 / 60
4
mm) Art. No.: 3410055251
2x Standard Phillips screwdriver (PH2)
PH2
Phillips screwdriver (PH2) 90° offset
PH2
4
Hexagon socket spanner SW 4
Pipe wrench SW 19
19
1x Open-ended spanner SW 10
2x Open-ended spanner SW 13
Tape rule or folding rule
↵
Finally acknowledge a process by pressing
the Start button (interior control panel).
Number of trained personnel required for
this maintenance task.
Number of qualified and authorised per-
sonnel required for this maintenance task.
The following chapters describe the work steps
required for carrying out maintenance and care
actions.
At the beginning of each chapter, the required tools
and aids are depicted, unless the corresponding
process can be carried out by one individual person
without any further auxiliary equipment.
The assembly is basically carried out in
reverse order of the disassembly.
Exceptions are especially pointed out.
If you open the bench part or one of the
acrylic panes, you must, after closing,
acknowledge a warning message appear-
ing on the interior control panel.
O p e r a t i n g I n s t r u c t i o n s | megaSun 7900
α
41
Advertisement
Table of Contents
