㉑
Pull the high-pressure lamp carefully out of its
㉑
holder. Use a clean and grease-free cloth.
㉒
Replace the spring washer.
INSTALLATION NOTE
Installation is made in reverse order. Make sure that
the high-pressure lamp is correctly positioned ㉓.
Interior unit lighting
The lighting from inside the tanning device is effected
by high-performance LEDs.There are LED modules
located inside the tanning device, in the canopy and
in the side part. The outer decorative lighting also
consists of LEDs. In the case of a defect, replacement
can only be made by qualified technical personnel.
Contact your service partner in this case.
LED boosters
In the case of a defect, replacement can only be
made by qualified technical personnel. Contact your
service partner in this case.
48
O p e r a t i n g I n s t r u c t i o n s | megaSun 7900
㉒
Spring washer
㉓
Centring lug
α
Filter cartridges
↵
The cooling air for canopy and bench is filtered.
Your tanning device is equipped with filter cartridges
and continuous-service filter inserts. Therefore,
purchase and replacement of conventional filter
pads are not required. Clean the filter inserts after
approx. 100 hours of operation, depending on the
local circumstances. Vacuum the filter inserts or
use a dishwasher.
Bench
There are four filter cartridges each in the canopy
and in the bench part.
NOTE
Take the opportunity and check and clean the
heat exchangers of the air-conditioning unit (See
also the chapter "Maintenance/Ventilation and air-
conditioning"). Soiled heat exchangers substantially
reduce the performance of the air-conditioner.
FILTER CARTRIDGES IN THE BENCH PART
㉔
⇒
Open the bench part.
㉔
Open the lock of the filter insert.
⇒
Remove the filter insert.
Canopy