Table of Contents
Advertisement
Variable section of the interior control panel
During the tanning session, you continue to have access to the settings you have made via the "preSelection"
function. If you wish to make any changes to your choice, you can do so in the variable section of the interior
control panel. By pressing one of the arrow buttons
available functions will be displayed one after the other according to the rotation principle.
You can switch these individual functions on or off and, if possible, make changes to the settings.
Prerequisite:
The functions must be available and activated in the service menu.
on
Air-conditioning
After the air-conditioning system
has been switched off, it cannot
be restarted for three minutes
for safety reasons. If the system
is switched on during this time,
the command will be stored. The
air-conditioning system will be
switched on automatically after a
delay, i.e. after the blocking time
has elapsed. If the condensate
canister is full, the following
symbol flashes on the interior
control panel display:
See also the chapter
"Maintenance/Air-conditioning
system".
off
20
O p e r a t i n g I n s t r u c t i o n s | megaSun 7900
Variable section of the
interior control panel
preSelection)
(
aquaCool
An ongoing spraying process cannot
be stopped. If the aquaCool supply is
running low, a corresponding message
is displayed in the standby mode. After
the message has appeared for the first
time, the aquaCool supply will last for
approximately another 2.5 hours of
operation. If the system has run out of
aquaCool liquid, the aquaCool function
is deactivated automatically, and the
symbol shown below is displayed.
aquaCool is automatically re-activated
as soon as a full canister has been
connected.
α
, above or below the changeover symbol
Selectable function symbols (for a fully
equipped tanning device).
MP3-int.
Studio
LED
aquaCool Aroma megaVoice
Aircon
III
II
LED
booster
I
0
, all
MP3-ext.
USB
Aroma
megaVoice
Advertisement
Table of Contents
