Start-Up; Operating Modes - KBL megaSun 7900 Alpha Operating Instructions Manual

Start-up

Before switching on for the first time:
• Fix the supplied warning sign or one with the
following wording permanently to the wall close to
the tanning device:
Warning
• UV-radiation can cause eye and skin damage as
well as skin aging and possibly skin cancer. Ask
the studio staff for further information.
• Wear protective goggles.
• Certain medicines or cosmetics can increase the
sensitivity of the skin to UV radiation. If in doubt,
consult a physician.
• Determine the presettings for the tanning device in
the service menu.
• Check correct installation of fluorescent tubes.
The tube labeling must be visible, otherwise no
tanning effect may be obtained.
• Store these Operating Instructions in a place that
allows for easy access at any time.

Operating modes

The three different operating modes and the fan
run-on mode are explained below:
STANDBY MODE
The tanning device is in an idle state, i.e. it is
connected to the mains but is currently not being
used. The tubes and the tanning lamps are switched
off. From the standby mode, you can change over to
the tanning mode or to the service mode.
TANNING MODE
The tubes and the tanning lamps are switched
on and a tanning session is in progress. While the
tanning device is in tanning mode, the settings for
the ongoing tanning session can be changed via the
interior control panel.
SERVICE MODE
In the service mode, the tanning device is configured
for the tanning mode. Various values can be displayed
and test functions can be carried out.
FAN RUN-ON
After the tanning session, the fan runs on for 3
minutes in order to cool down the tanning device.
The fan power is automatically decreased as the
tubes cool down.
O p e r a t i n g I n s t r u c t i o n s | megaSun 7900
α
13