Table of Contents
Advertisement
Maintenance and cleaning
Regular
maintenance
Maintenance intervals is required for the safe operation
of the tanning device and must be documented.
Cleaning and disinfection operations are carried
out in accordance with the enclosed cleaning and
disinfection instruction item no. 0100035823 (also
available at www.support.kbl.de).
• Depending on the level of knowledge required to
carry out maintenance work, it may only be done by
"trained persons" or exclusively by "qualified and
authorised personnel who have been instructed on
safety-related issues".
• Before carrying out any maintenance work, the tan-
ning device must be disconnected from the mains
voltage.
Live parts
Risk of fatal injury due to electric shock
when touching live parts.
• Disconnect from mains and secure
against reconnection!
• ONLY USE SPARE PARTS APPROVED
BY KBL.
• Replace illuminants and filters only with ones
which are characterized on the tanning device.
• Use only original KBL ballasts for smart
technology and CPI-Energy tanning devices.
Instructions on cleaning and
care
GENERAL
• Before starting to clean the tanning device take
off any rings, bracelets, watches, etc. that you
might be wearing in order to avoid scratching the
surfaces of the tanning device.
• Cleaning fluid and/or disinfectant must not run into
the tanning device.
40
O p e r a t i n g I n s t r u c t i o n s | megaSun 7900
as
shown
in
chapter
DANGER
α
TUBES
• To preserve the tanning power, we recommend
cleaning the tubes and UV lamps with warm water
and a chamois after approx. 200 hours of operation.
ACRYLIC PANES, GRAB HANDLES, PROTECTIVE
EYEWEAR
• If possible, use the special cleaning and disinfect-
ant agent "megaClean plus" supplied by KBL for
cleaning the acrylic parts and handles and dilute it
according to manufacturer instructions.
VARNISHED AND PLASTIC PARTS
• Use a damp soapy cloth to clean the varnished and
plastic surfaces.
• Do not clean the large plastic parts with a dry cloth.
This might scratch the surfaces!
CHROMIUM-PLATED PARTS/MIRROR
• Only clean with a damp chamois and a cleaning
agent for acrylic plastic (antistatic). Apply the
cleaning agent on the chamois and not directly on
the mirror surface.
CLEANING AGENTS
• The surfaces and the acrylic panes must not be
cleaned with concentrated disinfectants or solvents
or other liquids that contain alcohol.
CONTROL PANELS
• Use a suitable cleaning and disinfectant agent
(e.g. megaClean plus) and dilute it according to the
manufacturers information. Use a soft, only slightly
moistened lint-free cloth!Apply the cleaning agent
on the chamois and not directly on the mirror sur-
face.
Advertisement
Table of Contents
