REMOVING THE CANOPY PANE
4
PH2
It is not usually necessary to remove the canopy pane
for maintenance and cleaning operations. Should
you prefer to work with the canopy pane removed,
though, please proceed as follows:
PH2
⑥
⇒
Tilt the canopy pane down.
Remove the strain relief of the interior control
⑥
panel patch cable (Phillips screw M4).
⑦
Detach the patch cable.
↵
⑥
⑦
⑦
⑧
⑨
Call in a second person and hold the pane at
the two ends.
⑧
Then slightly lift the pane
from the rear holding section ⓑ.
Carefully pull the pane towards the front and
⑨
out of the tanning area.
⇒
Deposit the pane in a safe place.
ASSEMBLY NOTE
Proceed in reverse order in order to re-install the
canopy pane. Make sure that the pane seal is
correctly positioned.
When closing the canopy pane, make sure that
the pane seal is correctly positioned.
O p e r a t i n g I n s t r u c t i o n s | megaSun 7900
⑧
ⓐ
ⓑ
⑧
ⓐ
and remove it
α
43