Maintenance And Cleaning; Instructions For Cleaning And Care - KBL megaSun space 2000 Operating Instructions Manual

Hide thumbs Also See for megaSun space 2000:
Table of Contents

Advertisement

Maintenance and cleaning

Regular
maintenance
Maintenance intervals is required for the safe opera-
tion of the tanning device and must be documented.
Cleaning and disinfection operations are carried
out in accordance with the enclosed cleaning and
disinfection instruction item no. 0100035823 (also
available at www.support.kbl.de).
• Depending on the level of knowledge required to
carry out maintenance work, it may only be done by
"trained persons" or exclusively by "qualified and
authorised personnel who have been instructed on
safety-related issues".
• Before carrying out any maintenance work, the tan-
ning device must be disconnected from the mains
voltage.
Live parts
Risk of fatal injury due to electric shock
when touching live parts.
• Disconnect from mains and secure
against reconnection!
• USE USE SPARE PARTS APPROVED BY
KBL.
• Replace illuminants and filters only with ones
which are characterized on the tanning device.
Instructions for cleaning and
care
GENERAL
Before starting to clean the tanning device, take off
any rings, bracelets, watches, etc. that you might be
wearing in order to avoid scratching the surfaces.
Cleaning fluid must not run into the appliance.
as
shown
in
chapter
DANGER
TUBES
To preserve the tanning power, we recommend
cleaning the tubes and UV lamps with warm water
and a chamois after approx. 200 hours of operation.
ACRYLIC PANES, GRAB HANDLES, PROTECTIVE
EYEWEAR
For cleaning the acrylic panes, use the special
cleansing agent and disinfectant "megaClean plus"
supplied by KBL and dilute it according to manufac-
turer instructions.
VARNISHED AND PLASTIC PARTS
To clean the varnished and plastic surfaces, use a
damp soapy cloth.
Do not clean the big plastic parts with a dry cloth.
This might scratch the surfaces!
To clean the plastic surfaces of the door
the mirror plate of the floor, proceed as follows:
Use a damp chamois and spray megaClean plus onto
it sparingly. Then wipe the surfaces clean. NEVER
CLEAN WITH A DRY CLOTH!
Prevent the corners and edges from getting wet.
CLEANING AGENTS
The surfaces and the acrylic panes must not be
cleaned with concentrated disinfectants or sol-
vents or other liquids that contain alcohol!
CONTROL PANELS
Use a suitable cleaning and disinfectant agent (e.g.
megaClean plus) and dilute it according to the man-
ufacturers information. Use a soft, only slightly mois-
tened lint-free cloth!Apply the cleaning agent on the
chamois and not directly on the mirror surface.
O p e r a t i n g I n s t r u c t i o n s | megaSun space 2000
and
37

Advertisement

Table of Contents
loading

Table of Contents