R e m o v i n g t h e V R M
Grasp the VRM by its top corners, and ease it out of its connector.
4
Replacing the VRM
Align the slot on the bottom of the new VRM with the ridge inside the
1
connector.
Press the VRM straight into the connector.
2
Replace the VRM securing clip:
3
Lower the clip onto the VRM so that the top corners of the VRM
a
go through the slots in the clip.
Press down on the two raised points of the clip's top surface to
b
secure it to the VRM connector (see
Rotate the power supply back into position until the securing tab
4
snaps into the release latch.
press here to release
or secure the clip
securing clip
VRM
VRM connector
"Removing the
VRM").
161
VRM