Disconnect the speaker and chassis intrusion switch cables from the
8
control-panel connectors. To locate these connectors, see
Panel
Components."
Remove the mounting screw.
9
Lift the control panel and control-panel ribbon cable away from the
10
chassis.
R e m o v i n g t h e C o n t r o l P a n e l ( M i n i To w e r C h a s s i s )
control panel
guide pin
drive door
Replacing the Control Panel (Mini Tower Chassis)
NOTE:
When mounting the control panel on the drive door, Ensure that the
control-panel alignment hole is positioned over the guide pin. See
the Control Panel (Mini Tower
To replace the control panel, perform the
Chassis)."
removal procedure
"Control
control-panel
cable
cable routing
hole
mounting
screw
"Removing
in reverse.
121
Control Panel