Removing A Memory Module - Dell Precision 330 Service Manual

58 Sy st e m Me mo r y

Removing a Memory Module

CAUTION: Before you perform this procedure, see
Measures."
CAUTION: RIMMs can get very hot during system operation. Be
sure that the RIMMs have had sufficient time to cool before you
touch them.
NOTICE:
Before disconnecting a peripheral from the system or removing a
component from the system board, verify that the standby power indicator on
the system board has turned off. To locate this indicator, see
Components" or "Interior Service
Turn off the computer and peripherals, disconnect them from their
1
electrical outlets, wait at least 5 seconds, and then
computer cover.
If you have a mini tower chassis, lay the computer down on its right
2
side.
Rotate the power supply
3
Remove the memory modules (RIMMs or CRIMMs):
4
Press the securing clips at each end of the socket outward
a
simultaneously until the module pops out slightly from the socket
(see the following figure).
Lift the module away from the socket.
b
NOTE: If you remove a module (RIMM or CRIMM), you must install
another module in the empty socket before turning on the computer.
Label."
away from the system board.
"Precautionary
"System Board
remove the